Contact CCW Technical Service for more information on product inspection if the freeze indicator has been broken. Open drums or totes bearing broken freeze indicators and inspect material for sludge, particles or separation. Inspect freeze indicator on the drum or tote to verify if it has been broken from exposure to freezing temperatures. Verify that the product is within shelf life, as indicated on the product label. Obtain full, safe access to the area and mask adjacent surfaces to protect from overspray. On concrete masonry unit (CMU) construction, mortar joints shall be free of voids and struck flush and mortar droppings shall be removed from surfaces. Grind fins and similar protrusions flush. Fill form tie holes, honeycomb and voids with non-shrink grout or CCW-703 V Liquiseal. These shall be removed prior to application by power washing or other suitable method. Verify that surfaces are free of visible surface moisture, loose materials, release oils and other contaminants. Concrete shall be cured in place for a minimum of 3 days as long as the foundation wall is backfilled within 24 hours. Verify material is within its product shelf life andįreeze/thaw indicator on pallet has not broken off from exposure to freezing temperatures. Prior to application, mask off all adjacent surfaces to protect from overspray and drips. Barricoat waterproofing and MiraDRAIN drainage composite are combined for a complete, warranted foundation waterproofing system by CCW. Can be applied to damp or green concrete allowing application more quickly after the removal. TREMdri 160 is compatible with cast in place, poured concrete, shotcrete, and Nudura® Insulated Concrete Forms (ICF). ![]() Barricoat is for use on vertical surfaces and can be applied directly to concrete, concrete masonry, insulated concrete forms (XPS) and many other common building materials. Typical applications for TREMdri 160 include foundation and basement walls and most backfilled, unsubmerged residential applications. Barricoat is a waterproofing and vapor barrier membrane for use in below-grade foundation wall assemblies. Carlisle Barricoat can be applied through co-spray, 1-part spray or roller application to achieve a nominal 0.060-inch (60 mils) dry film thickness membrane. This product contains chemicals known to the state of California to cause birth or developmental defects.Carlisle Barricoat: Waterproofing Asphalt EmulsionĬarlisle Barricoat is a water-borne asphalt emulsion modified with a blend of synthetic polymers and special additives. CALIFORNIA PROPOSITION 65 CHEMICAL WARNING: Clean tools with water immediately after use. Allow material to dry and cure for 24 hours prior to application of foam or drainage boards or backfilling. Apply material at a rate of 150 square feet per 4.75 gallon pail. Apply using either a brush, trowel, or airless spray unit (suggested tip size. Do not apply if rain is imminent or forecast within 24 hours of application. Stop coating by early afternoon (3:00 pm) to prevent wash off, which will occur if dew, fog, or rain arrives before coating dries. In areas where dew or fog accumulates in the early evening, it is best to coat in the morning. Be sure to wear eye protection and gloves when mixing and applying this product. Do not apply when temperature is expected to drop below 50º F within a 24- hour period. ![]() Application temperature must be a minimum of 60º F and rising. Surface shall be clean, dry and free of any dirt or contaminants. ![]() Protects concrete foundations from moisture and water intrusion. DescriptionĪn elastomeric polymer modified asphalt emulsion designed for coating concrete foundations & roofs.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |